Tuesday, April 18, 2017

6x6 Swamp Tiles Are Now Downloadable at DrivethruRPG

Yup, I been busy doin' tha art thang. Find the HERE.



I've also been looking into a way to coat my tiles to make them work with wet erase markers. The only advice online that I could find was to cover the tiles with a sheet of poster frame plastic. That's great, but not portable. It would be great if I could pre-draw any features on my tiles and transport them to the game.

Here's what I have done so far:

Lamination - Ordinarily would work, however the side lips of the lamination would interfere with the tiles abilities to butt up against each other.

Modge Podge Glossy Acrylic Sealer Spray - I put three coats on a tile but the ink still bled through to the paper underneath. It might work if I added more coats, but I don't want to spend $10 per can and have it only treat 6 tiles. I have a lot of these things. Plus a knowledgeable friend advised me that Acrylics can yellow the work, wear off, and don't age well.

PVA Glue (Elmer's) - I honestly thought this would work and it almost did. The problem is that PVA glue is water-soluble, even after it has dried. As soon as I used a wet rag to erase the ink, the glue became liquid again and things went bad.

Polyurethane Spray (Glossy) - My knowledgeable friend suggested this and it is also about $10 per spray can. You can get it from Home Depot. It will take longer to cure but can likely do the job in two coats. We'll see.

And speaking of Home Depot, they have this little "Start your own fairy garden" miniatures for $2 a miniature.  There was a great, to-scale Water Well that I picked up. everything else wasn't much use to me. Not a bad find.


No comments:

Post a Comment